Sharpe Mixers
    Company
    Directions
   
Online Store

    Parts & Service
Mixers

    Portable Mixers
    E-Series Mixers
    N-Series Mixers
    V-Series Mixers
Impellers
    Marine Propeller
    Hyflo Impeller
    Axial Impeller
    Radial Impeller
    Anchor Impeller
    Helix Impeller
    Folding Impeller
    Hub Attachments/Options
Shafts & Seals
   
Shafting
    Dust/Vapor Seals
    Stuffing Glands
    Mechanical Seals
Other Options
    Steady Bearings
    Materials, Coatings
      & Polishings

    Options and Accessories
Markets
    Chemical
    Fluid Gas Desulferization
    Food and Beverage
    Pharmaceutical
      and Biotechnology

    Pulp and Paper
    Water and Wastewater
      Treatment

Literature
    Mixer Selection Guide
    Brochures
    O&M Manuals
    Disassembly Instructions
    Sales Drawings

    Literature Request Sheet

 Sharpe E-Series Mixers

E-Series Mixer

Brochure 

The Sharpe E-series worm gear drive meets low headroom requirements without sacrificing performance.

Standard c-face motor mounting id designed for simple trouble-free installation, with positive registers for repeatable alignment.  Efficient "high pressure angle" gearing provides extremely quiet operation and high shock-load capacity. The hollow quill gearbox design uses oversize tapered roller bearing for long overhung shafts, and requires no flange coupling for assembly. Heat and shock loading is isolated between the motor and gearbox.

The E-Series mixers are available in top and side entering designs, with mountings ranging from simple open-tank plate mounts to complex mechanical seal systems.  Sizes range from fractional to 75 horsepower.  Drive housing is corrosion resistant cast iron. Wetted parts are SS316 standard. Carbon steel, exotic alloys, or coatings are also available when required.